When using the thor continuous laser beam welding should pay attention to what issues?

Please note that when using the thor continuous laser beam welding pay attention to the following items?

1, the machine working conditions should be dry, the operator should wear plastic or rubber shoes.

2, the machine can not replace the power sensor system.

3, published, or test by ultrasonic machine in work, never put your hand welding mode, to avoid ultrasonic vibration and the high pressure injuries.

4, long-term operator recommends earplugs, noise can avoid the damage.

Five, the work or test can not directly contact welding or metal mould jig machine base.

6, when processing, the odour of plastic accessories, factory should have good ventilation.

7, if you notice than the common noise or heating of transducer system to 50 ℃ and above, should immediately stop the work frequency of the operation and testing machine, check the normal operation of the machine.

8, machine fuse fuse, replace immediately without power, well-trained technical personnel should check the relevant parts of the machine to verify whether no failure after start to avoid failure.